open 7 days a week

(604) 682-3788

 

Fuel Polishing

Over any given period of time fuels in storage can develop pools of sludge, sediment and water caused by microbial contamination. This contamination can quite easily find its way into fuel at one of the many exchange points in its journey from source to end user. Left untreated, the levels of contamination worsen to the point where damage to machinery, pumps and engines is likely. When fuel is pumped into a tank condensation, atmospheric absorption, and a faulty tank are usually the main causes of fuel contamination. Microbes find their way into fuel and cause problems as they multiply and grow.

In essence "polishing" is an advanced level filtration of the fuel, monitored and controlled via a central processing unit. Its application ensures the need for fuel additives is either massively reduced or totally removed. A typical process involves a single pass of the fuel through different apparatus, removing increasingly finer contaminant in each stage. The application of different filter technologies is vital; a single process is not sufficient to extract the different forms of water and matter found in fuel.

 

During the fuel polishing process, multiple stages are required to effectively remove the solid particulates, wet foreign matter and water from the fuel. This multi-stage process ensures the high efficiency of the process, however ensuring dense matter removal first is key, as is the removal of large matter on the suction side of the internal pumping stage. High pressurization of fuel contamination is notoriously dangerous and as such the majority of the polishing process should be carried out on the suction side. The pressure side process is often refereed to as the final or finishing stage, where 2 micron particulate[4] is removed and the fuel's final water content is extracted to within the efficiency of the filter stages.

 

The amount of time required to complete the fuel polishing process depends on several factors. One of the most important in the specific fuel polishing machine used. Fuel cleaning machines can polish at rates from 8 litres per minute to upwards of 400 litres per minute, however the factors which govern the process are about more than just flow rate. In fact a high flow rate can be detrimental to the overall effect due to increased pressures in the filter stages and adverse disturbance in the fuel tank. Another factor can be the quality of the fuel. If the fuel is highly contaminated it will typically take longer to clean than a batch of cleaner fuel of the same volume. The third factor to take into account is the volume of fuel to be processed. It may seem obvious but the larger the volume of fuel that requires polishing, the longer it will take to complete the cleaning process.

Custom designed and built fuel polisher by Bob McKnight.

Back to Top of Page

Back to Services Page

© 2016 SK Designs

(604) 682-3788

© 2016 SK Designs